Unscrew the wall push button. On the back, loosen the screws securing the cables connecting the wall push button to your garage/gate opener. Place the supplied “Y” connectors in the same place of the aforementioned cables (polarity does not matter). Tighten the screws back and reassemble the wall push button.

NOTE:

If you have enabled door 1 use cables out of terminals #1 and #2.

If you have enabled door 2 use cables out of terminals #3 and #4.

If you have enabled door 3 use cables out of terminals #5 and #6.

NOTE: Some customers may prefer to connect the Gogogate2 in the back of the opener. To do this, please check the wiring instructions here: https://www.gogogate.com/compatibility-checker . If your garage door opener / gate opener is not on the list, contact our specialists: support@gogogate.com sending the brand and model of your garage door opener / gate opener and we will respond as soon as possible.